PSE Economical 16 Channel Rackable Wireless Handheld, Headset or Lavalier Mic System (UHF)

HH52 Dynamic Wireless Handheld Microphone

Galaxy Audio HH52 Dynamic Handheld Microphone Transmitter for the PSE/ECM Wireless Microphone System

• Dynamic Microphone Element
• On/Off Switch
• IR Sync Transmitter to Receiver
• High/Low RF Switch
• 10 mW / 5 mW
• Metal Chassis
• Operates on 2 AA Batteries (up to 8 hours Alkaline
• Dimensions: 9.8″ x 2.1″ (250 x 53 mm) (L x Dia.)
• Weight: 9.5 oz. (270 g)

MBP52 Wireless Microphone Body Pack for PSE & ECM Systems

Wireless Microphone Body Pack Transmitter for the PSE/ECM Wireless Microphone Systems

• Low Battery Indicator
• 3 Position Switch
• IR Sync Transmitter to Receiver
• Mic/0/-10dB
• Operates on 2 AA Batteries (up to 8 hours Alkaline)
• Dimensions: 3.3″ x 2.6″ x 1″ (85 x 65 x 24 mm) (HxWxD)
• Weight: 2.8 oz (80 g)

LV-U3BK

This affordable lav mic comes standard with the ECM, PSE, TRC, DHT, DHX, CTS, & Traveler Lavalier Systems. The LV-U3BK unidirectional lapel microphone works with Galaxy Audio transmitters.

• Uni-Directional
• Lapel / Lavalier
• TA3F Connector

HS-U3BK Uni Headset

This uni-directional headset comes standard with the ECM, PSE, TRC, DHT, DHX, CTS, & Traveler Headset Systems. It’s comfortable wrap around design goes over both ears and helps ensure that this mic will stay in place. The HS-U3BK uni headset microphone can be wired to work with transmitters made by Galaxy Audio®, Shure®, Sennheiser®, AKG®, and Audio Technica®, as well as most other brands of wireless microphone systems.

• Uni directional headset microphone
• Hooks over both ears

MREWD

Single and Dual Monitor Rack Mount Kit, includes 1 long rack ear, 2 short rack ear, 2 coupler plates, and assorted screws. The MREWD allows for racking a single or two wireless in-ear monitors systems or wireless mic systems in a 1U space. Works with PSE, DHX, CTS, AS-900, AS-1100, & AS-1400 systems.

Antenna Distributor ANT-DISTDC

The Wireless Microphone Antenna Distribution System expands wireless microphone systems only, by splitting one pair of antennas to allow up to four single channel receivers to use the same antennas. 3dB gain compensates for any insertion loss and increases receive signal range (up to 275ft). Low-loss 50 ohm BNC connectors for mounting antenna. Includes rack ears for mounting rack space (1RU) Distributes the antenna for up to 4 Wireless Microphone Systems (PSE, CTS, and DHX Series). BNC connectors, single rack space, combines power for up to four wireless receivers as well.
Note: Only works with wireless microphone receivers. This Wireless Microphone Antenna Distribution System does NOT work with In-Ear systems.

• Combines Antennas for up to 4 mic receivers
• Four DC outputs eliminate individual power supplies
• 500MHz-900MHz Range
• Built in Antenna Booster
• Increase receiver signal rans up to 275 ft more
• 3dB Gain Compensaton
• 19″ Rack Space

ANT-PDL

Wireless Directional Antenna used to decrease interference to other equipment.  Frequency range 500-900MHz

The UHF wide-band (500-900 MHZ) directional LPDA (log periodic dipole array) antenna reduces outside interference while providing increased send/receive signal range. Each antenna paddle is matched to 50 ohms impedance with a low-loss BNC connector; 7dBi gain. Professional wireless antenna for permanent or temporary installation; mounts to 5/8″-27 threads.

It is suggested that the angle between the paddle antenna and the thransmitter should be from 90º to 120º. Normally the effective range can reach about 300′.

• 500-900 MHz
• LPDA antenna
• 7dBi gain
• Can mount to mic stand
• Improves Range

19.69” BNC Cable & Connector Combo

This Includes:
One Wire BNC Connector Cable (Part# CN-BNCPM) and
One 19.69″ (50 cm) RG58 Cable (Part# EXTBNC) for front mounting antenna.

MICCLIPSI

Standard Mic Clip for Handheld Microphones